Testing the fit

The van conversion is moving along. Due to insurance requirements I had to pull seats from the passenger compartment, so this was the starting position:

The intent is to lift the bed high enough to allow for storage underneath, but I’m nervous about stability. Here’s the first attempt:
Unfortunately by the time I got the unit set up a storm was rolling in, so the image is a little dark, but I think the main idea is clear. The base is over 30″ high, with a further 6″ for the foam mattress, so I will need to provide a step or two in order for Daniella to climb aboard (I’ll need a little help myself!).

I will have to raise the mattress another inch or so – it’s a double, and is just slightly longer than the inside of the van is wide, so I can either raise the mattress so that it encroaches on the window “sill” area very slightly or cut the mattress to fit the limited space available. Cutting is irreversible, so that isn’t really an option.

This part of the project allowed me to give my router table a workout, and it worked out quite well, along with the Porter & Cable 1 1/4 HP router. I can’t say the same for the Bosch palm router I used for other parts of the project, as the collet came loose a couple of times, allowing the bit to drop slightly while I was cutting a slot. Perhaps the bit’s shank was a little undersized so that the collet couldn’t tighten properly. In any case, the net result was a ragged cut, and I’ll have to do a little work to smooth it out.

So far I’ve managed to keep everything removable, so in a pinch the van can be restored to its original condition with the exception of one row of passenger seating. That will change once I start adding electrical connections, but I will continue trying to keep changes minimal.

If it matters, construction is in 1×2 maple and 12mm maple plywood, and is currently held together entirely by glue and friction fitting in slots routed into the 1x2s. The mattress base is built from 1×4 maple spanned by a set of slats from IKEA. I’ll peg everything later, and probably reinforce the interior corners with further bracing.

Stay tuned…there will be more!